Unclog a liquid soap pump
Do not force anything apart or disassemble the head of the pump. Fill the sink with hot water, and place the pump parts in the sink. Soak the pump for several minutes. Use the scrub brush or toothbrush to scrub the pump, especially at connection points and the opening of the pump head.
This will remove any dry soap residue. Fill the soap vessel, or, for a built-in pump, a small bowl, with hot water. Reassemble the pump top. For a freestanding pump, reattach it to the vessel; for a built-in pump, place the straw in the bowl of water. Use the paperclip to clean the pump head. Straighten the paper clip and push it through the disassembled straw. Use the point of the paper clip to dig soap residue out of the opening of the pump head.
Flush a large volume of hot water from the faucet through the pump straw and head to remove any remaining residue. Don't throw away a clogged soap dispenser. It is easy and fast to fix the clog. Disassemble and Clean the Pump. Step 1 Disassemble the pump by unscrewing the lid and removing it from the base.
This is done to loosen up the soap residues. Leave it untouched for half an hour. If there are hard deposits of soap, then you can soak it overnight in a tub of hot water. After soaking, take a small scrub brush or toothbrush and rub it over the opening of the pump head and other connection points where maximum deposits occur.
Finally rinse off with plain water. Any solid particles that are stuck in the hole of the dispenser pump head can be cleaned with the help of a paperclip. Make the paperclip straight and push it into the opening of the pump head. Any other narrow crevices in the pump should be clean up in the same manner.
Wash with water to clean up the removed soapy particles. Then you have to clean up the tube connected to the pump. Now, if it is detachable, then you can place it directly under the tap of hot water and pass water through it to clean up any clogging material stuck inside it. If it cannot be detached, then turn the pump upside down and run some hot water through it to clean up some of the residues. Then take a small pipe cleaner, put it inside the tube and run it back and forth motions.
Then move it in circular motions to thoroughly clean up all debris that are still there. You have to clean up the interiors of the body of the dispenser.
If there is mold or mildew growth inside the dispenser, then it can clog up its pipe and pump time and again. To get rid of mold and mildew growth, use a five percent bleach solution.
Fill this solution into the dispenser and keep it untouched for about half an hour. The drain it out and rinse the dispenser thoroughly with water. Finally, take a little liquid dishwashing soap on a wet sponge and rub it on the outer part of the dispenser and wash it off. Once you have cleaned up all the parts of the dispenser, then it is time to reassemble it. After reassembling, you must check if it is working.
For this, fill up half the dispenser with water and press the pump. If water it coming out of it freely, then you can fill it up with soap and start using it. You can prevent clogging up of the soap dispenser in future, by cleaning it up after a gap of every few months.
If you are cleaning it regularly, you do not have to soak it for hours and you can finish off the cleaning job in an hour or so. How to Choose the Right Soap Dispenser. Small Bathroom Makeover Ideas. Ceramic Tile Shower Ideas: Paint Colors for Bathrooms.
Bathroom Wall Art Ideas. Rubber Duck Bathroom Decor. Bathroom Color Schemes and Accessories. Top Bathroom Colors